Barometric Pressure Module, BMP180, Arduino, Raspberry-Pi


Barometric Pressure Module, BMP180, Arduino, Raspberry-Pi
Stock Number: 31546 MP
  Be the first to review this item
$5.95


This item is NO LONGER available. Please use our SEARCH feature and see if you can find an alternate item for what you were looking for.



SHARE
    
     Email this to a friend     

Detailed Description

UPDATED Arduino Digital Pressure Sensor Module
Arduino powered sensor for reading Barometric Pressure (altitude) and Temperature. Built in temp. compensation, Analog/Digital Converter and Control.
Full on board calibration.
4 modes for pressure: Ultra low power, Standard, High Resoultion, Ultra High Resolution.
Power: 3.3V or 4.5-12VDC using On-board 3.3V Regulator
Peak Current: 1mA max During Conversion
Noise: <0.02hPa (17cm)
Detector: BOSCH BMP180
Outputs: I2C
Data Rate: 3.5mHz
Word Length: 16 /19 bit pressure 16bit temperature
Pressure Range: 300-1100hPa
-500 to +9000M above sea level
Conversion Time: 4.5mS to 25.5 depending on Mode
Temperature Range: 0-65C
5 Pin I/O header.
L: 9/16” W: 1/2” H: 1/8” WT: .002

View PDF Data Sheet


California Proposition 65 Warning WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
(This item was manufactured prior to August 31st, 2018)



Recently Viewed Items